Save the Page and run it to see the Integration Record data as required:ħ. In the Page Designer, amend the SourceExpr, Name and Caption as shown below to ensure that the Record ID value is formatted correctly:Ħ. Add all table fields to the new Page and click the “Finish” button:ĥ. Select “Create a Page using a wizard” using the List option:Ĥ. Specify the page should be built on table id 5151 (Integration Record).ģ. Create a new Page in the Microsoft Dynamics NAV Development Environment.Ģ. The steps below will give the desired result:ġ. The solution is to create a Dynamics NAV Page to enable you to format the Record ID into human readable format. This can make troubleshooting a CRM Connector problem difficult as the Record ID is often required to associate a change transaction with a specific row in the relevant NAV table. If you try to look at the contents of this table you will see the following: In earlier version of Navision and in table permission set, security filter was updated by the field name and but in new version of Navision it is updated by Field Number. If you install the CRM Connector for Microsoft Dynamics NAV 2013 you will find that you cannot read the “Record ID” value directly in the Integration Record table as you used to in Microsoft Dynamics NAV 2009 R2. The Permission set contain a permission with Security Filter in NAV 2009.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |