![]() ![]() If I find some time tomorrow, I will see if I can scan my tables and send them to you. I wish I had a copy of the complete tables I could email you, the following link is mounting and dismounting catalog that has tables in the back, but does not have all of what you are looking for. Are you sure you are not looking at H tolerance tables? The capital H is for holes and all of those are 0 to a plus number.Īfter you have used it a bit, these tolerances get easier. The +43 on the h9 tolerance is definitely wrong, all the h tolerances are +0 and a negative number. Permissible deviations for linear dimensions except chamfered parts (external radii and chamfer heights, see Table 2.) Unit : mm Tolerance class. I'm using a book published by FAG Bearings that lists the complete tolerance range for each designation, I don't have my Machinerys Handbook here to check and see what is in there. General Tolerance - Iso 2768-mh (din 7168) (jis B 0419) Table 1. Bearing tolerances are usually fairly tight since that controls the amount of internal clearance of the rolling elements to the race of the bearing when installed.Īn M6 tolerance on a 47mm bore should be -4 to -20 according to my book.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |